Driver numérique moteur pas à pas Modbus RS485 Leadshine 50V / 5.6A – 7 entrées et 3 sorties programmables

EM2RS-556 Modbus stepper driver

- Power supply from 20 to 50VDC. Output current from 0.5 to 5.6A.
- Modbus RS485 control
- Speed, Position, Homing modes
7 programmable digital inputs ( Limit, Origin, Quick stop, Alarm reset, Enable, JOG or Position Table inputs)
3 digital outputs (Alarm, Brake, Homing / Instruction / Path complete)

98.60 € Without Taxes 98.60000000000001 EUR 98.60 €

98.60 €

~~118.32 €~~ 118.32 € with taxes

Brand
Inputs
- 7
Outputs
- 3
Min. Voltage
Max. Voltage
Max. current
Configurable
- via RS232 cable
Interface

This combination does not exist.

AJOUTER AU PANIER

Product Documents

Using Modbus with Leadshine Drivers

Manuel rapide Motion Studio

Manuel EM2RS

Datasheet EM2RS

Internal Reference: EM2RS-556

Specs

Support for Modbus RTU communication using an isolated RS485 bus
Supply voltage 20-50VDC, max output current 5.6A
HMI, PLC or external I/O control the movement
7 programmable inputs: Limit, Home, Quick Stop, Alarm Reset, Enable, JOG or Position Table
3 programmable outputs: alarm, brake, homing / instruction / route completed
Operating modes: velocity profile, position mode, homing
Protections against overvoltages, overcurrents, motor wiring errors, etc.
Modbus identifier and communication speed adjustable by switches
Current and resolution setting via Motion Studio parameterization software (RS232 interface)
Small dimensions (118x79.5x25.5mm)
Pluggable connectors

Introduction

The EM2RS series is a stepper driver generation based on the standard Modbus RTU protocol, using RS485 communication, which allows networking up to 31 axes.
Their built-in PR function with 16-segment position table (PR mode) can dispense with additional controllers in most point-to-point applications, greatly improving system reliability and reducing costs.

Applications

The EM2RS series also supports the teach function, position profile, velocity profile, and homing operation modes. The EM2RS-556 can power 2-phase stepper motors in NEMA 17, 23, and 24 formats.

Electrical specifications

(Tj=25℃)

Parameters	EM2RS-556
Min.	Min	Typical	Max
Output current	1.8	-	5.6 (4A RMS)	Amps
Voltage (DC)	20	24-48	50	VDC
Current for logic signals	7	10	16	mA
Input signal frequency	0	-	10	Khz
Input signal voltage	12	-	24	VDC

Mechanical Specifications (Unit: mm, 1 inch=25.4 mm)

Figure 1

Typical connection

Logiciel de paramétrage Leadshine Motion Studio V1.49 :
https://www.leadshine.com/upfiles/downloads/4f2e3904b60df00acb75d9cd2ae65491_1702632536136.zip

Accessories

Specifications

Brand	Leadshine
Inputs	7
Outputs	3
Min. Voltage	20 V
Max. Voltage	50 V
Max. current	5.6 A
Configurable	via RS232 cable
Interface	Modbus RS485